Hardware
Every identified component on the board, and what it does.
| Status | Meaning |
|---|---|
| Verified | Observed on the device or established from authenticated images |
| Partly | The connection is proven, the behaviour is not |
| Claimed | Manufacturer specification only, not independently confirmed |
| Unknown | Not established |
Board wiring that has not been authenticated lives in the kernel’s provenance-pending device
tree, disabled by default (CONFIG_GQ5012BF1_PENDING_BOARD_DT=n).
No component here has been exercised under a LieppOS-built kernel. Hardware validation is 0.
Compute and memory
| Component | What it does | Status |
|---|---|---|
| MediaTek MT6878 (MT6878T) | Main SoC: arm64 CPU, Mali GPU, ISP, modem, and the SCP co-processor that runs the sensors | Verified |
| RAM | 16 GB LPDDR. Boot reports exactly 17179869184 bytes; LPDDR generation and part number are not identified | Verified (size) |
| RAM expansion | Up to 16 GB of storage-backed virtual RAM, sold as Dynamic RAM Expansion | Claimed |
| UFS storage | Flash holding every partition, driven by the ufs-mediatek-mod module | Verified |
| TrustKernel (tkcore) | Secure-world OS beside Android; handles fingerprint authentication and secure memory. Stock binaries, never redistributed | Verified |
| GenieZone | MediaTek protected execution environment for trusted workloads | Verified |
Display and touch
| Component | What it does | Status |
|---|---|---|
yft-lcm-vtdr6115-drv | Main LCD, 1080x2400, 60/90/120 Hz, density 480, on card0-DSI-1 | Verified |
| FocalTech FT3680 | Main touchscreen on SPI3, ten simultaneous points | Verified |
spi_tiny_lcd_co5300 | Rear 1.04 inch 340x340 AMOLED, over SPI0 via spi_tiny_co5300_lcd.ko | Verified |
Hynitron hyn_ts | Rear touch panel on I2C 0-0015, single tracking point | Verified |
The rear screen is not a second Android display. It is a vendor misc device
(/sys/class/misc/tiny_lcd_miscdev) that the YftMiniScreen app draws watch faces and
notifications onto. Android’s compositor never sees it.
Cameras
| ID | Sensor | Facing | Role | Flash |
|---|---|---|---|---|
| 0 | Sony IMX989 | Rear | Main | Yes |
| 1 | Samsung S5KJN1 | Front | Selfie | No |
| 2 | Samsung S5KJN1MAIN2 | Rear | Ultra-wide | Yes |
| 3 | OmniVision OV64B | Rear | 64 MP night vision | Yes |
| Component | What it does | Status |
|---|---|---|
| MediaTek ISP7SP | Image processor: demosaic, denoise, HDR and colour for all sensors | Verified |
mtk_ccuv.ko | Camera control unit driver coordinating sensors and ISP | Verified |
| VCM motors | Autofocus voice-coil actuators on the rear cameras | Verified |
| OIS | Optical stabilisation for the main camera | Verified |
| EEPROMs | Per-module calibration storage for each camera | Verified |
| AW36515 / AW36518 | Flash and torch LED drivers | Verified |
| ThermoVue T2 | Thermal sensor: 640x512, 25 Hz, 12 um pitch, under 40 mK, -20 to 550 C | Claimed (spec) / Verified (driver and APK) |
yft_tiny2c_usb | Driver at I2C 8-003c controlling the thermal module USB and sensor mode | Partly |
ThermoVue Pro (com.energy.tc2c) | Thermal camera app, AC020 and UVC native stack, 17 bundled calibration assets | Partly |
The thermal camera is separate from the four normal cameras: it is a USB device with its own control path, not a Camera2 sensor. The night-vision claim on the OV64B is marketing; the sensor and its IR illuminators are present, but low-light performance has never been measured.
Audio
| Component | What it does | Status |
|---|---|---|
| MT6369 codec | Audio codec and headset detection, under SPMI second_pmic@5 | Verified |
| MT6878 AFE | Audio front end at 11050000, feeding the codec into Android audio stack | Verified |
| Two analog microphones | Bottom mic on AIN0/UL1_CH1, back mic on AIN2/UL1_CH2 | Partly |
| Awinic AW88394 | Loudspeaker amplifier at I2C 6-0034, chip ID 0x2049 | Verified |
| Loudspeaker and earpiece | At least one external speaker plus the call earpiece | Verified |
| 3.5 mm headphone jack | Wired headset output and mic input, with insert detection | Verified |
There is no built-in front microphone; the cameras use the normal two-mic array. Microphone part numbers and acoustic orientation need PCB inspection, and stereo layout is unconfirmed.
Sensors
All five physical sensors are driven by firmware on the SCP co-processor, not by Linux. Linux sees
only scp.ko, sensorhub.ko and hf_manager.ko, which relay data to Android.
| Sensor | Measures | Vendor | Status |
|---|---|---|---|
| ICM4N607 | Acceleration and rotation rate | iven_sense | Verified |
| MMC5603 | Magnetic field, for compass heading | memsic | Verified |
| STK3A5X ALS | Ambient light, for screen brightness | sensortek | Verified |
| STK3A5X PS | Proximity, blanking the screen during calls | sensortek | Verified |
| SPL07 | Atmospheric pressure, for altitude and weather | goer | Verified |
Android exposes 22 sensors. The other 17 are computed by MediaTek sensor fusion from these five: orientation, gravity, linear acceleration, rotation vectors, step counter and detector, tilt, significant motion, wake gestures and device orientation.
Power and charging
| Component | What it does | Status |
|---|---|---|
| MT6375 | Primary battery gauge and charger controller at I2C 5-0034; also supplies USB OTG power | Verified |
| SH366003 | Pack fuel gauge at I2C 9-0055, exported as 3rd-gauge; the real pack readings Android publishes | Verified |
| SC8571 (master) | Charge pump at I2C 11-0066 (primary_dvchg), stepping voltage down for fast charging | Verified |
| SC8571 (slave) | Second charge pump at I2C 6-0067 (secondary_dvchg), in parallel for high current | Verified |
| SC8510 | Switched-capacitor converter at I2C 6-0069; static configuration and IRQ shim only | Partly |
| Thermal limit | Thresholds |
|---|---|
| CPU, GPU, NPU, TPU, SoC | 85 / 90 / 100 / 117 C |
| Battery | 50 / 55 / 59 / 60 C |
The pack reads 8.4 V and charges toward 8.9 V, pointing to two cells in series; the exact wiring needs a schematic. The 120 W negotiation is not in the SC8571 driver; it lives in MediaTek charger policy, which has not been reconstructed.
Connectivity
| Component | What it does | Status |
|---|---|---|
| ST21NFC | NFC controller at I2C 6-0008 with st21nfc_fw.bin and st21nfc_fw7.bin; exposes SIM1 and SIM2 secure elements | Verified |
| NFC antenna | Coil driven by the ST21NFC controller | Verified |
| CONNAC2 WLAN | Wi-Fi via connsys_wifi firmware and wlan_* modules | Partly |
| CONNAC2 Bluetooth | Bluetooth via connsys_bt and bt_drv_6878 | Partly |
| CONNAC2 GNSS | GPS, GLONASS, BeiDou and Galileo via connsys_gnss and the LBS service | Partly |
| MediaTek modem | Cellular baseband with md1dsp, md1arm7 and md3img; dual-SIM dual-standby | Partly |
| Antennas | Cellular, Wi-Fi, Bluetooth and GNSS antennas are present but not individually characterised | Unknown |
Hardware and firmware are identified for every radio, but no radio behaviour has been tested: no band scan, no call, no data session, no cold GNSS start, no NFC poll.
Modem identity, NV and calibration partitions are unique to each device. They must never be wiped, copied into a repository or regenerated from extraction.
Expansion and I/O
| Component | What it does | Status |
|---|---|---|
| USB Type-C | Shared MTU3, xHCI and USB2 PHY; carries charging, data, OTG and the thermal camera. USB 2.0 only, no SuperSpeed evidence | Verified |
| USB-PD | Power Delivery with PPS; supports OTG host mode | Verified |
| SIM slots | Two nano-SIM slots, dual-SIM dual-standby | Verified |
| microSD slot | Dedicated slot, up to 2 TB | Verified (slot) / Claimed (capacity) |
| uSmart | Accessory interface on the same shared USB fabric | Verified |
There are three physical slots: nano-SIM, nano-SIM and microSD. No eSIM hardware was found.
Feedback and controls
| Component | What it does | Status |
|---|---|---|
| Vibration motor | ERM type (no LRA resonance), handled by vendor.vibrator-default; click, tick and texture effects. Driver IC not identified | Verified (type) |
| Power button | KEY_POWER | Verified |
| Volume up / down | KEY_VOLUMEUP / KEY_VOLUMEDOWN | Verified |
| Two programmable keys | yft-gpio-keys, emitting F1 and F2; likely the rugged side buttons | Verified |
| AW2013 | RGB notification LED at I2C 11-0045, used for charging status | Verified |
| Fingerprint | SPI1 sensor with microarray_fp_tee and /dev/tkcore_fp, authenticating through TrustKernel | Partly |
The fingerprint transport is proven; whether authentication completes end to end is untested.
Lights and infrared
| Component | What it does | Status |
|---|---|---|
| AW36515 work light | Main lamp, rated 1000 lm from 570 LEDs at 5 W, driven by YftOutdoorLightUlefone | Verified (driver) / Claimed (output) |
| AW36518_v2 warning light | Red and blue emergency lamp with constant and blink modes, driven by YftRedBlueLight | Verified (driver) / Claimed (brightness) |
| Consumer IR | Remote-control transmitter: /dev/lirc0 to mtk_irtx_pwm.ko to PWM0 to mt6369_vio28 at 2.8 V; carriers at 30, 33, 36, 38, 40 and 56 kHz | Partly |
| IR emitter | The optical emitter itself has never been confirmed to fire | Unknown |
The IR software chain is complete and the carrier frequencies are known from the stock HAL, but no one has verified the emitter physically transmits.
Thermal and cooling
| Component | What it does | Status |
|---|---|---|
| Active fan | None; there is no fan service | Verified |
| Passive cooling | Graphite, copper foil, heat pipe or vapour chamber; material not determined | Unknown |
| Thermal zones | CPU, GPU, NPU, TPU, SoC, skin, battery, USB port and power amplifier | Verified |
| Cooling devices | Mali GPU, charger, LCD backlight, Wi-Fi and flashlight throttling | Verified |
The thermal HAL is AIDL v3 and exposes all of these through Android thermal framework.
Rugged construction
| Property | Value | Status |
|---|---|---|
| Dimensions | 177.35 x 85.6 x 33.8 mm | Claimed |
| Weight | 688 g | Claimed |
| Ingress protection | IP68 (2 m for 30 min) and IP69K | Claimed |
| Shock and vibration | MIL-STD-810H | Claimed |
| Underwater camera use | Photo and video start, stop and mode switching underwater | Claimed |
| Glove mode | Possibly supported by the touch controller | Unknown |
| SOS hardware | Not identified | Unknown |
These are manufacturer certifications. None has been independently tested here.
What remains unidentified
- RAM manufacturer, part number and LPDDR generation.
- Vibration motor driver IC.
- Speaker count, stereo layout and microphone part numbers.
- Passive cooling materials.
- Individual antenna types and counts, beyond the NFC coil.
- PMIC topology and exact charger arbitration.
- PCB revision history.
- Whether the IR emitter, work light and warning light actually perform as specified.
See Known limitations and Partition map.
Sources: research hardware/MASTER-HARDWARE-INVENTORY.md, and docs/hardware-map.md,
sensors.md, connectivity.md, camera-thermal.md, display-secondary.md,
battery-charging.md, audio.md, ir-blaster.md.